Is there a fire near Albany, GA right now?

Wildfires near Albany, GA

Updated

3 fire clusters within 80 km; nearest 47 km SSW, 1 detection in the last 48 h Latest satellite pass with a detection: Sun 3:33 pm local (2026-10-25 19:33 UTC).

Live satellite fire detections within 80 km of Albany, Georgia, United States, grouped into fire clusters, with the wind direction for smoke. Times are local (America/New_York).

Fire clusters within 80 km
3 last 48 h
Nearest fire
47 km SSW 47 km SSW of Albany
Hotspot detections nearby
10 VIIRS 375 m pixels, last 48 h
Strongest fire radiative power
9 MW low-intensity

Open on the live map

Fires near Albany, GA right now

NASA's VIIRS sensors detected 10 thermal hotspots in 3 separate clusters within 80 km of Albany, Georgia, United States in the last 48 h. The closest is 47 km SSW of the city centre (47 km SSW of Albany), with 1 detection and a peak fire radiative power of 3 MW, which is low-intensity for a single 375 m pixel.

None of the clusters is within 25 km of the centre, so the city itself is not in the immediate fire area, but smoke can travel hundreds of kilometres.

Every nearby cluster is low intensity (peak under 10 MW), which is typical of agricultural or garden burning, industrial heat sources such as steel works or flares, or small fires rather than a spreading wildfire.

The largest nearby cluster by detections is 71 km W (66 km NE of Dothan) with 8 detections; first seen Sun 1 pm and last seen Sun 3 pm local time.

Across United States there are 577 fire clusters in the same window, 19 of them in Georgia.

Fire clusterFrom cityDetectionsPeak FRPFirst seenLast seen
47 km SSW of Albany47 km SSW13 MWSat 2:11 pmSat 2:11 pm
66 km NE of Dothan71 km W89 MWSun 1:54 pmSun 3:33 pm
45 km WNW of Valdosta75 km SE10 MWSun 4:16 amSun 4:16 am

Smoke and wind

Current wind data was unavailable for this page; smoke generally drifts with the wind, so check local conditions.

Smoke shows up first as PM2.5 on air-quality monitors; the Albany, GA air quality page has the live reading.

Evacuations and official information

GodsView shows satellite detections only. It does not know fire perimeters, containment or evacuation zones. Always follow evacuation orders from local authorities.

InciWeb (inciweb.wildfire.gov) lists federal wildfire incidents. Evacuation orders come from county sheriffs and emergency management, often via Genasys Protect (protect.genasys.com) or local alert apps.

About satellite fire detections

Satellite thermal hotspots are not all wildfires: gas flares, steel works, volcanoes and planned agricultural or prescribed burns show up too. VIIRS passes over most places about twice a day, so a fire can start or grow between passes, and thick smoke or cloud can hide one.

Fire radiative power (FRP) is the heat a fire gives off, in megawatts per pixel: under 10 MW is usually a small or smouldering fire, over 100 MW an intense flaming front.

Wildfires near other cities

More for this area

Data: NASA FIRMS (VIIRS active fires), Open-Meteo, GeoNames.