Is there a fire near Erie right now?

Wildfires near Erie, PA

Updated

2 fire clusters within 80 km; nearest 74 km NNW, 2 detections in the last 48 h Latest satellite pass with a detection: Sun 4:11 am local (2026-10-25 08:11 UTC).

Live satellite fire detections within 80 km of Erie, Pennsylvania, United States, grouped into fire clusters, with the wind direction for smoke. Times are local (America/New_York).

Fire clusters within 80 km
2 last 48 h
Nearest fire
74 km NNW 6 km SSE of Simcoe
Hotspot detections nearby
17 VIIRS 375 m pixels, last 48 h
Strongest fire radiative power
27 MW low-intensity
Wind now
N 8 km/h gusts 9 km/h, humidity 45%

Open on the live map

Fires near Erie right now

NASA's VIIRS sensors detected 17 thermal hotspots in 2 separate clusters within 80 km of Erie, Pennsylvania, United States in the last 48 h. The closest is 74 km NNW of the city centre (6 km SSE of Simcoe), with 2 detections and a peak fire radiative power of 27 MW, which is low-intensity for a single 375 m pixel.

None of the clusters is within 25 km of the centre, so the city itself is not in the immediate fire area, but smoke can travel hundreds of kilometres.

The largest nearby cluster by detections is 74 km N (17 km E of Simcoe) with 15 detections; first seen Sat 2 am and last seen Sun 4 am local time.

Across United States there are 573 fire clusters in the same window, 6 of them in Pennsylvania.

Fire clusterFrom cityDetectionsPeak FRPFirst seenLast seen
6 km SSE of Simcoe74 km NNW227 MWSat 2:13 pmSat 2:13 pm
17 km E of Simcoe74 km N1513 MWSat 2:50 amSun 4:11 am

Smoke and wind

Wind at Erie is from the N at 8 km/h (gusts 9 km/h), so smoke near the city drifts toward the S. Relative humidity is 45% and the temperature 16°C.

Erie is roughly downwind of the nearest fire, so smoke and haze are likely; check the air quality page before spending time outdoors.

Smoke shows up first as PM2.5 on air-quality monitors; the Erie air quality page has the live reading.

Evacuations and official information

GodsView shows satellite detections only. It does not know fire perimeters, containment or evacuation zones. Always follow evacuation orders from local authorities.

InciWeb (inciweb.wildfire.gov) lists federal wildfire incidents. Evacuation orders come from county sheriffs and emergency management, often via Genasys Protect (protect.genasys.com) or local alert apps.

About satellite fire detections

Satellite thermal hotspots are not all wildfires: gas flares, steel works, volcanoes and planned agricultural or prescribed burns show up too. VIIRS passes over most places about twice a day, so a fire can start or grow between passes, and thick smoke or cloud can hide one.

Fire radiative power (FRP) is the heat a fire gives off, in megawatts per pixel: under 10 MW is usually a small or smouldering fire, over 100 MW an intense flaming front.

Wildfires near other cities

More for this area

Data: NASA FIRMS (VIIRS active fires), Open-Meteo, GeoNames.