Is there a fire near Shoreline right now?

Wildfires near Shoreline, WA

Updated

1 fire cluster within 80 km; nearest 21 km S, 3 detections in the last 48 h Latest satellite pass with a detection: Sat 3:11 am local (2026-10-24 10:11 UTC).

Live satellite fire detections within 80 km of Shoreline, Washington, United States, grouped into fire clusters, with the wind direction for smoke. Times are local (America/Los_Angeles).

Fire clusters within 80 km
1 last 48 h
Nearest fire
21 km S 5 km SSW of Seattle
Hotspot detections nearby
3 VIIRS 375 m pixels, last 48 h
Strongest fire radiative power
3 MW low-intensity
Wind now
SSE 13 km/h gusts 31 km/h, humidity 78%

Open on the live map

Fires near Shoreline right now

NASA's VIIRS sensors detected 3 thermal hotspots in 1 separate cluster within 80 km of Shoreline, Washington, United States in the last 48 h. The closest is 21 km S of the city centre (5 km SSW of Seattle), with 3 detections and a peak fire radiative power of 3 MW, which is low-intensity for a single 375 m pixel.

1 cluster is within 25 km, close enough that smoke, ash or road closures may affect the city. Distances are measured from the city centre to the nearest detection, not to the fire's edge.

Every nearby cluster is low intensity (peak under 10 MW), which is typical of agricultural or garden burning, industrial heat sources such as steel works or flares, or small fires rather than a spreading wildfire.

Across United States there are 573 fire clusters in the same window, 5 of them in Washington.

Fire clusterFrom cityDetectionsPeak FRPFirst seenLast seen
5 km SSW of Seattle21 km S33 MWSat 3:11 amSat 3:11 am

Smoke and wind

Wind at Shoreline is from the SSE at 13 km/h (gusts 31 km/h), so smoke near the city drifts toward the NNW. Relative humidity is 78% and the temperature 12°C.

Shoreline is roughly downwind of the nearest fire, so smoke and haze are likely; check the air quality page before spending time outdoors.

Smoke shows up first as PM2.5 on air-quality monitors; the Shoreline air quality page has the live reading.

Evacuations and official information

GodsView shows satellite detections only. It does not know fire perimeters, containment or evacuation zones. Always follow evacuation orders from local authorities.

InciWeb (inciweb.wildfire.gov) lists federal wildfire incidents; in this state also check the Washington DNR (dnr.wa.gov). Evacuation orders come from county sheriffs and emergency management, often via Genasys Protect (protect.genasys.com) or local alert apps.

About satellite fire detections

Satellite thermal hotspots are not all wildfires: gas flares, steel works, volcanoes and planned agricultural or prescribed burns show up too. VIIRS passes over most places about twice a day, so a fire can start or grow between passes, and thick smoke or cloud can hide one.

Fire radiative power (FRP) is the heat a fire gives off, in megawatts per pixel: under 10 MW is usually a small or smouldering fire, over 100 MW an intense flaming front.

Wildfires near other cities

More for this area

Data: NASA FIRMS (VIIRS active fires), Open-Meteo, GeoNames.