Is there a fire near St. Charles right now?
Wildfires near St. Charles, MD
Updated
1 fire cluster within 80 km; nearest 78 km SW, 1 detection in the last 48 h Latest satellite pass with a detection: Sat 2:52 am local (2026-10-24 06:52 UTC).
Live satellite fire detections within 80 km of St. Charles, Maryland, United States, grouped into fire clusters, with the wind direction for smoke. Times are local (America/New_York).
- Fire clusters within 80 km
- 1 last 48 h
- Nearest fire
- 78 km SW 57 km SSW of Dale City
- Hotspot detections nearby
- 1 VIIRS 375 m pixels, last 48 h
- Strongest fire radiative power
- 1 MW low-intensity
Fires near St. Charles right now
NASA's VIIRS sensors detected 1 thermal hotspot in 1 separate cluster within 80 km of St. Charles, Maryland, United States in the last 48 h. The closest is 78 km SW of the city centre (57 km SSW of Dale City), with 1 detection and a peak fire radiative power of 1 MW, which is low-intensity for a single 375 m pixel.
None of the clusters is within 25 km of the centre, so the city itself is not in the immediate fire area, but smoke can travel hundreds of kilometres.
Every nearby cluster is low intensity (peak under 10 MW), which is typical of agricultural or garden burning, industrial heat sources such as steel works or flares, or small fires rather than a spreading wildfire.
Across United States there are 577 fire clusters in the same window, 1 of them in Maryland.
| Fire cluster | From city | Detections | Peak FRP | First seen | Last seen |
|---|---|---|---|---|---|
| 57 km SSW of Dale City | 78 km SW | 1 | 1 MW | Sat 2:52 am | Sat 2:52 am |
Smoke and wind
Current wind data was unavailable for this page; smoke generally drifts with the wind, so check local conditions.
Smoke shows up first as PM2.5 on air-quality monitors; the St. Charles air quality page has the live reading.
Evacuations and official information
GodsView shows satellite detections only. It does not know fire perimeters, containment or evacuation zones. Always follow evacuation orders from local authorities.
InciWeb (inciweb.wildfire.gov) lists federal wildfire incidents. Evacuation orders come from county sheriffs and emergency management, often via Genasys Protect (protect.genasys.com) or local alert apps.
About satellite fire detections
Satellite thermal hotspots are not all wildfires: gas flares, steel works, volcanoes and planned agricultural or prescribed burns show up too. VIIRS passes over most places about twice a day, so a fire can start or grow between passes, and thick smoke or cloud can hide one.
Fire radiative power (FRP) is the heat a fire gives off, in megawatts per pixel: under 10 MW is usually a small or smouldering fire, over 100 MW an intense flaming front.
Wildfires near other cities
More for this area
Data: NASA FIRMS (VIIRS active fires), Open-Meteo, GeoNames.