Is there a fire near Wollongong right now?

Bushfires near Wollongong, NSW

Updated

4 fire clusters within 80 km; nearest 4 km SSW, 9 detections in the last 48 h Latest satellite pass with a detection: Sun 3:02 pm local (2026-10-25 04:02 UTC).

Live satellite fire detections within 80 km of Wollongong, New South Wales, Australia, grouped into fire clusters, with the wind direction for smoke. Times are local (Australia/Sydney).

Fire clusters within 80 km
4 last 48 h
Nearest fire
4 km SSW 4 km SSW of Wollongong
Hotspot detections nearby
13 VIIRS 375 m pixels, last 48 h
Strongest fire radiative power
8 MW low-intensity
Wind now
SSW 16 km/h gusts 45 km/h, humidity 87%

Open on the live map

Fires near Wollongong right now

NASA's VIIRS sensors detected 13 thermal hotspots in 4 separate clusters within 80 km of Wollongong, New South Wales, Australia in the last 48 h. The closest is 4 km SSW of the city centre (4 km SSW of Wollongong), with 9 detections and a peak fire radiative power of 8 MW, which is low-intensity for a single 375 m pixel.

1 cluster is within 25 km, close enough that smoke, ash or road closures may affect the city. Distances are measured from the city centre to the nearest detection, not to the fire's edge.

Every nearby cluster is low intensity (peak under 10 MW), which is typical of agricultural or garden burning, industrial heat sources such as steel works or flares, or small fires rather than a spreading wildfire.

Across Australia there are 294 fire clusters in the same window, 16 of them in New South Wales.

Fire clusterFrom cityDetectionsPeak FRPFirst seenLast seen
4 km SSW of Wollongong4 km SSW98 MWSat 3:19 pmSun 2:39 am
15 km SSE of Liverpool42 km N11 MWSun 2:39 amSun 2:39 am
15 km WNW of Liverpool61 km NNW12 MWSun 3:02 pmSun 3:02 pm
15 km WNW of Parramatta73 km N21 MWSun 2:39 amSun 2:39 am

Smoke and wind

Wind at Wollongong is from the SSW at 16 km/h (gusts 45 km/h), so smoke near the city drifts toward the NNE. Relative humidity is 87% and the temperature 16°C.

Wollongong is roughly downwind of the nearest fire, so smoke and haze are likely; check the air quality page before spending time outdoors.

Smoke shows up first as PM2.5 on air-quality monitors; the Wollongong air quality page has the live reading.

Evacuations and official information

GodsView shows satellite detections only. It does not know fire perimeters, containment or evacuation zones. Always follow evacuation orders from local authorities.

Bushfire warnings in Australia are issued by state services; here that is NSW Rural Fire Service (rfs.nsw.gov.au, Hazards Near Me app). Follow the Australian Warning System levels (Advice, Watch and Act, Emergency Warning).

About satellite fire detections

Satellite thermal hotspots are not all wildfires: gas flares, steel works, volcanoes and planned agricultural or prescribed burns show up too. VIIRS passes over most places about twice a day, so a fire can start or grow between passes, and thick smoke or cloud can hide one.

Fire radiative power (FRP) is the heat a fire gives off, in megawatts per pixel: under 10 MW is usually a small or smouldering fire, over 100 MW an intense flaming front.

Wildfires near other cities

More for this area

Data: NASA FIRMS (VIIRS active fires), Open-Meteo, GeoNames.