Is there a fire near Bendigo right now?

Bushfires near Bendigo, VIC

Updated

1 fire cluster within 80 km; nearest 73 km SSE, 1 detection in the last 48 h Latest satellite pass with a detection: Mon 2:22 am local (2026-10-25 15:22 UTC).

Live satellite fire detections within 80 km of Bendigo, Victoria, Australia, grouped into fire clusters, with the wind direction for smoke. Times are local (Australia/Melbourne).

Fire clusters within 80 km
1 last 48 h
Nearest fire
73 km SSE 47 km NNW of St Albans
Hotspot detections nearby
1 VIIRS 375 m pixels, last 48 h
Strongest fire radiative power
1 MW low-intensity
Wind now
SW 10 km/h gusts 23 km/h, humidity 80%

Open on the live map

Fires near Bendigo right now

NASA's VIIRS sensors detected 1 thermal hotspot in 1 separate cluster within 80 km of Bendigo, Victoria, Australia in the last 48 h. The closest is 73 km SSE of the city centre (47 km NNW of St Albans), with 1 detection and a peak fire radiative power of 1 MW, which is low-intensity for a single 375 m pixel.

None of the clusters is within 25 km of the centre, so the city itself is not in the immediate fire area, but smoke can travel hundreds of kilometres.

Every nearby cluster is low intensity (peak under 10 MW), which is typical of agricultural or garden burning, industrial heat sources such as steel works or flares, or small fires rather than a spreading wildfire.

Across Australia there are 313 fire clusters in the same window, 6 of them in Victoria.

Fire clusterFrom cityDetectionsPeak FRPFirst seenLast seen
47 km NNW of St Albans73 km SSE11 MWMon 2:22 amMon 2:22 am

Smoke and wind

Wind at Bendigo is from the SW at 10 km/h (gusts 23 km/h), so smoke near the city drifts toward the NE. Relative humidity is 80% and the temperature 8°C.

Bendigo is not directly downwind of the nearest fire at the moment, though winds shift and plumes from larger fires can still reach the city.

Smoke shows up first as PM2.5 on air-quality monitors; the Bendigo air quality page has the live reading.

Evacuations and official information

GodsView shows satellite detections only. It does not know fire perimeters, containment or evacuation zones. Always follow evacuation orders from local authorities.

Bushfire warnings in Australia are issued by state services; here that is VicEmergency (emergency.vic.gov.au). Follow the Australian Warning System levels (Advice, Watch and Act, Emergency Warning).

About satellite fire detections

Satellite thermal hotspots are not all wildfires: gas flares, steel works, volcanoes and planned agricultural or prescribed burns show up too. VIIRS passes over most places about twice a day, so a fire can start or grow between passes, and thick smoke or cloud can hide one.

Fire radiative power (FRP) is the heat a fire gives off, in megawatts per pixel: under 10 MW is usually a small or smouldering fire, over 100 MW an intense flaming front.

Wildfires near other cities

More for this area

Data: NASA FIRMS (VIIRS active fires), Open-Meteo, GeoNames.