Is there a fire near Geelong right now?

Bushfires near Geelong, VIC

Updated

1 fire cluster within 80 km; nearest 51 km NE, 3 detections in the last 48 h Latest satellite pass with a detection: Mon 2:22 am local (2026-10-25 15:22 UTC).

Live satellite fire detections within 80 km of Geelong, Victoria, Australia, grouped into fire clusters, with the wind direction for smoke. Times are local (Australia/Melbourne).

Fire clusters within 80 km
1 last 48 h
Nearest fire
51 km NE 8 km SSW of St Albans
Hotspot detections nearby
3 VIIRS 375 m pixels, last 48 h
Strongest fire radiative power
2 MW low-intensity
Wind now
WNW 13 km/h gusts 27 km/h, humidity 90%

Open on the live map

Fires near Geelong right now

NASA's VIIRS sensors detected 3 thermal hotspots in 1 separate cluster within 80 km of Geelong, Victoria, Australia in the last 48 h. The closest is 51 km NE of the city centre (8 km SSW of St Albans), with 3 detections and a peak fire radiative power of 2 MW, which is low-intensity for a single 375 m pixel.

None of the clusters is within 25 km of the centre, so the city itself is not in the immediate fire area, but smoke can travel hundreds of kilometres.

Every nearby cluster is low intensity (peak under 10 MW), which is typical of agricultural or garden burning, industrial heat sources such as steel works or flares, or small fires rather than a spreading wildfire.

Across Australia there are 294 fire clusters in the same window, 6 of them in Victoria.

Fire clusterFrom cityDetectionsPeak FRPFirst seenLast seen
8 km SSW of St Albans51 km NE32 MWMon 2:22 amMon 2:22 am

Smoke and wind

Wind at Geelong is from the WNW at 13 km/h (gusts 27 km/h), so smoke near the city drifts toward the ESE. Relative humidity is 90% and the temperature 7°C.

Geelong is not directly downwind of the nearest fire at the moment, though winds shift and plumes from larger fires can still reach the city.

Smoke shows up first as PM2.5 on air-quality monitors; the Geelong air quality page has the live reading.

Evacuations and official information

GodsView shows satellite detections only. It does not know fire perimeters, containment or evacuation zones. Always follow evacuation orders from local authorities.

Bushfire warnings in Australia are issued by state services; here that is VicEmergency (emergency.vic.gov.au). Follow the Australian Warning System levels (Advice, Watch and Act, Emergency Warning).

About satellite fire detections

Satellite thermal hotspots are not all wildfires: gas flares, steel works, volcanoes and planned agricultural or prescribed burns show up too. VIIRS passes over most places about twice a day, so a fire can start or grow between passes, and thick smoke or cloud can hide one.

Fire radiative power (FRP) is the heat a fire gives off, in megawatts per pixel: under 10 MW is usually a small or smouldering fire, over 100 MW an intense flaming front.

Wildfires near other cities

More for this area

Data: NASA FIRMS (VIIRS active fires), Open-Meteo, GeoNames.